CIOE 2021 (The 23rd China International Optoelectronic Exposition), as the world’s leading optoelectronic exhibition, will be held at Shenzhen World Exhibition & Convention Center on September 16-18,...
Learn More >
Should be based on the machine tool processing capacity, processing material performance, processing process, cutting dosage and other factors to choose a reasonable tool. The general principle of ...
Learn More >
As quenched steel has good performance, it is widely used in transportation industry, wind power industry, machine tool industry, die industry and other fields. Typical parts include gear, gear shaft,...
Learn More >
There are two common errors in end face machining. One is turning the end face into a concave surface, and the other is turning the end face into a convex surface. How do these two errors occur? How t...
Learn More >
The key to gear machining is tooth surface machining. At present, the main methods of tooth surface machining are tool cutting and grinding wheel grinding. According to the processing principle, it ca...
Learn More >
Determine the entering angle of the tool Among the entering angles of conventional tools, the ones suitable for finishing are generally between 90° and 95°, especially 91°, 93°, and 95° which are m...
Learn More >
Reason 1 Poor fixture rigidity Solution 1. Analyze the direction of the cutting force and provide sufficient support or improve the fixture 2. By reducing the amount of back knife ap 3....
Learn More >
Workpiece name: Fresnel lens Workpiece material: copper The maximum corrugation can be within 50 nanometers, and the cutting edge has no chipping edge under 200 times microscope.
Learn More >
