(1). The rake angles may be positive, zero or negative. (2). An increased rake angle will reduce the strength of the cutting edge. (3). Rake angle affects the values of cutting angle and the ...
Learn More >
1. Replacement of passivated sand. When the passivation time of 400# sand tool is more than 20 minutes, the sand needs to be replaced or redeployed. 2. After the replacement of new sand, the passiv...
Learn More >
Coating of tools is one of the important ways to improve tool performance. The emergence of coated tools has greatly improved the cutting performance of tools, and the application fields have been exp...
Learn More >
Moresuperhard can provide ultra - thin ( hub type and hubless type) diamond dicing blade for scribing silicon wafers, compound semiconductor wafers (GaAs, Gap), oxide wafers (LiTaO3), glass, crystal,...
Learn More >
What are the problems of reamer reaming and how to solve them? 1. The aperture increases, the error is largeThe design value of the outer diameter of the reamer is too large or
Learn More >
MCD single crystal milling cutter processes solar collector, the quality is ＞0.1 g, smallest tools tips is ＜2 mm,which can processing high precision and low surface roughness of workpiece.
Learn More >
The BP neural network can automatically use 15% of the 64 samples obtained from the full factor cutting test as the test group, and the remaining samples as the training group. The training group will...
Learn More >
The above analysis shows that there is no interaction between surface roughness and backdraft, feed and cutting speed. According to the roughness results in Table 5, the main effect diagram of surface...
Learn More >
