The cutting gear is installed on the working structure of shearer and roadheader for cutting coal and rock directly. In the process of coal production, the consumption of a large number of picks not o...
Learn More >
In recent years, the producers and users of diamond products pay more and more attention to the thermal stability of the products. At present, the evaluation of the properties of diamond products is n...
Learn More >
Linear velocity has the greatest influence on tool life. If the linear speed is higher than 20% of the specified linear speed of the sample, the tool life will be reduced by half. If increased to 50%,...
Learn More >
Tool life is the total cutting time of a new tool from the start of cutting until the tool is scrapped. In numerical control machining, tool life refers to the time that the tool tip cuts the workpiec...
Learn More >
Engine as a key part of the automobile, its cylinder block and cylinder head material is mostly aluminum alloy material, parts of the processing accuracy requirements are high, the traditional tool is...
Learn More >
Diamond has poor thermal stability. The hardness is greatly reduced when the cutting temperature reaches 800 degrees Celsius. Diamond tools are not suitable for processing iron and steel materials, be...
Learn More >
Grinding rack refers to the rack after heat treatment, to the tooth surface and all sides of grinding treatment, grinding off burr and deformation, improve the accuracy of the rack, the general grindi...
Learn More >
At present, the grinding of single crystal diamond tools can be divided into mechanical grinding and non-pure mechanical grinding two methods, in addition to the original mechanical grinding based on ...
Learn More >
